River dyke failure modeling under transient water conditions


Book Description

Knowledge of the performance of river dykes during flooding is necessary when designing governmental assistance plans aimed to reduce both casualties and material damage. This is especially relevant when floods have increased in their frequency during the last decades, together with the resulting material damage and life costs. Most of previous attempts for analyzing dyke breaching during flooding have neglected to consider the soil mechanics component and the influence of infiltration and saturation changes on the failure mechanisms developed in the river dyke. This research project aimed to fill that gap in knowledge by analyzing, in a comprehensive manner, the effect of transient water conditions, represented by successive flood cycles, on the seepage conditions and subsequent breaching of dykes. Therefore, three key sub-projects were carried out: • the analysis of the results from an overflow field test, • the physical modeling of small-scaled models under an enhanced gravity field, • the numerical modeling of the flow response and the resulting stability of both the air- and water-side slopes. The results from the numerical simulations matched accurately with the results obtained with the centrifuge modeling, including the prediction of local instabilities during the flood cycles for those dykes that did not include a toe filter.










Static effects and aspects of feasibility and design of drainages in tunnelling


Book Description

This PhD thesis investigates the effectiveness of drainage measures with respect to two particularly important problems associated with tunnelling through water-bearing, weak ground: the stability of the tunnel face and the stability and deformation of grouting bodies. Water is an adverse factor with respect to the stability and deformation of underground structures due to the pore water pressure and the seepage forces associated with seepage flow towards the tunnel. Drainage boreholes reduce the pore water pressure and the seepage forces in the vicinity of the cavity. Furthermore, loss of pore water pressure increases the effective stresses and thus the shearing resistance of the ground („consolidation“), which is favourable in terms the deformation occurring during and after tunnelling. The goal of the PhD thesis is to elaborate a more detailed understanding of the interrelationships between drainage measures and the stability of the tunnel face and grouting bodies. The main objectives of the investigations relating to the tunnel face are: 1. analysis of face stability through limit equilibrium computations taking account of the numerically determined seepage flow conditions prevailing in the ground after the implementation of drainage measures; 2. systematic investigation of tunnel face stability considering several different drainage layouts and working out designnomograms; 3. consideration of a series of aspects limiting pore pressure relief and thus the effectiveness of drainage measures and their impact on face stability. The main objectives of the investigations with regard to grouting bodies are: 1. a study of the stabilizing effect of the virtual case of ideal drainage on tunnel support and plastification in grouted fault zones in plane strain conditions; 2. a comparison with the stabilizing effect of real drainage layouts, i.e. when considering pore pressure relief due to specific drainage borehole arrangements; 3. application of the drainage measure both before and after the injection works. In summary, the contribution of this PhD thesis is the detailed investigation of the static effects of drainage measures during tunnelling in water-bearing ground with respect to the stability of the tunnel face and the grouting body as well as the supply of design aids capable of providing a quick assessment of face stability when considering a number of advance drainage schemes.




On the role of constitutive behaviour in the response of squeezing ground to tunnelling


Book Description

Squeezing conditions in tunnelling are characterized by the occurrence of large deformations of the opening or high rock pressure that may overstress the lining. Squeezing is associated with poor quality rock. Tunnelling in squeezing ground involves great uncertainties. It is therefore very important to gain a better understanding of the underlying mechanisms. Triaxial testing is the main source of information in order to understand the mechanical features of squeezing ground. Despite the complexity of the squeezing mechanism and the behaviour observed under relatively simple loading conditions, most of previous research work and engineering design practice considers the ground as a linearly elastic, perfectly plastic material obeying the Mohr-Coulomb yield criterion. While the MC model is capable of predicting the final strength and post-failure volumetric behaviour of the squeezing rock, it cannot map some potentially important pre-failure features or the occasionally observed contractant plastic deformation. In addition, the MC model usually leads to an overestimation of the strength under undrained conditions, which is unsafe for tunnel design. The present thesis mainly addresses the influence of constitutive modelling on predictions about the response of squeezing ground to tunnelling in order to provide some general guidelines for basic engineering analysis. This objective is achieved by investigating the behaviour of squeezing rocks theoretically and experimentally, using samples from several tunnel projects, including the Gotthard base tunnel and the planned Gibraltar strait tunnel.




Physical Modelling in Geotechnics, Volume 2


Book Description

Physical Modelling in Geotechnics collects more than 1500 pages of peer-reviewed papers written by researchers from over 30 countries, and presented at the 9th International Conference on Physical Modelling in Geotechnics 2018 (City, University of London, UK 17-20 July 2018). The ICPMG series has grown such that two volumes of proceedings were required to publish all contributions. The books represent a substantial body of work in four years. Physical Modelling in Geotechnics contains 230 papers, including eight keynote and themed lectures representing the state-of-the-art in physical modelling research in aspects as diverse as fundamental modelling including sensors, imaging, modelling techniques and scaling, onshore and offshore foundations, dams and embankments, retaining walls and deep excavations, ground improvement and environmental engineering, tunnels and geohazards including significant contributions in the area of seismic engineering. ISSMGE TC104 have identified areas for special attention including education in physical modelling and the promotion of physical modelling to industry. With this in mind there is a special themed paper on education, focusing on both undergraduate and postgraduate teaching as well as practicing geotechnical engineers. Physical modelling has entered a new era with the advent of exciting work on real time interfaces between physical and numerical modelling and the growth of facilities and expertise that enable development of so called ‘megafuges’ of 1000gtonne capacity or more; capable of modelling the largest and most complex of geotechnical challenges. Physical Modelling in Geotechnics will be of interest to professionals, engineers and academics interested or involved in geotechnics, geotechnical engineering and related areas. The 9th International Conference on Physical Modelling in Geotechnics was organised by the Multi Scale Geotechnical Engineering Research Centre at City, University of London under the auspices of Technical Committee 104 of the International Society for Soil Mechanics and Geotechnical Engineering (ISSMGE). City, University of London, are pleased to host the prestigious international conference for the first time having initiated and hosted the first regional conference, Eurofuge, ten years ago in 2008. Quadrennial regional conferences in both Europe and Asia are now well established events giving doctoral researchers, in particular, the opportunity to attend an international conference in this rapidly evolving specialist area. This is volume 2 of a 2-volume set.







Internal Erosion in Earthdams, Dikes and Levees


Book Description

This book gathers the peer-reviewed contributions presented at the 26th Annual Meeting of the European Working Group on Internal Erosion in Embankment Dams, Levees and Dikes, and their Foundations (EWG-IE), held in Milano, Italy, on 10-13 September 2018. The meeting served as a fertile platform for discussion, sharing sound knowledge and introducing novel ideas on issues related to soil internal erosion in water retaining structures. The contributions encompass various aspects of laboratory techniques and findings, modelling and design criteria as well as prevention measures and field assessment. The book is a valuable, up-to-date tool that provides an essential overview of the subject for scientists and practitioners alike, and inspires further investigations and research.










Recent Books