Effects of Thermal Shrinkage on Built-up Roofing


Book Description

The effects of thermal movement of bituminous built-up roof membranes are related to some common failures of built-up roofing observed in field exposures.A procedure for determining the amount of thermal movement of built-up membranes is described.Data are given for the thermal movement of various bitumens and reinforcing felts used in the con * struction of built-up roofs and for the composite membranes over a temperature range construction of built-up roofs and for the composite membranes over a temperature range of +30 to -30F.The data obtained are related to field experience and suggestions are presented which will prove beneficial in reducing the incidence of built-up failure due to thermal movement.(Author).
















Laboratory-field Comparisons of Built-up Roofing Membranes


Book Description

The values of breaking load, elongation and thermal expansion of nine bituminous built-up membranes prepared by roofing contractors under field conditions and by technicians in the laboratory were measured at sub-freezing temperatures.The data indicated that the field-prepared specimens agreed favorably with laboratory-prepared specimens, although the samples from the field frequently reflected higher values for thermal-shock resistance than did their laboratory-prepared counterparts.The higher values were attributed to the smaller amounts of bitumen used between the plies of the field specimens.The results appeared to support the validity of the application of the 'strength-thickness rule' to bituminous built-up membranes.(Author).




Thermal-shock Resistance for Built-up Membranes


Book Description

The resistance of bituminous built-up roofing membranes to thermally induced forces is considered in terms of their strength properties such as breaking load in tension, modulus of elongation and apparent linear thermal expansion coefficient.The development of a Thermal-Shock Resistance Factor is described and values are given for three bituminous built-up membranes at temperatures of - 30F (-34.4C), 0F (-17.8C), 30F (-1.1C) and 73F (22.8C).The apparent relation between the values obtained in the laboratory and the observed performance of roofing membranes in service is considered.The utilization of the Thermal-Shock Resistance Factor in the reduction of potential failures of bituminous built-up roofing membranes in service from thermally induced forces is also discussed.(Author).