Ultra High Bypass Ratio Low Noise Engine Study


Book Description

A study was conducted to identify engine cycle and technologies needed for a regional aircraft which could be capable of achieving a 10 EPNdB reduction in community noise level relative to current FAR36 Stage 3 limits. The study was directed toward 100-passenger regional aircraft with engine configurations in the 15,000 pound thrust class. The study focused on Ultra High Bypass Ratio (UHBR) cycles due to low exhaust jet velocities and reduced fan tip speeds. The baseline engine for this study employed a gear-driven, 1000 ft/sec tip speed fan and had a cruise bypass ratio of 14:1. A revised engine configuration employing fan and turbine design improvements are predicted to be 9.2 dB below current takeoff limits and 12.8 dB below current approach limits. An economic analysis was also done by estimating Direct Operating Cost (DOC). Dalton, W. N., III Glenn Research Center NAS3-25950; WBS 22-781-30-12




Ultra-High Bypass Engine Aeroacoustic Study


Book Description

A system study was carried out to identify potential advanced aircraft engine concepts and cycles which could be capable of achieving a 5 to 10 EPNdB reduction in community noise level relative to current FAR36 Stage 3 limits for a typical large-capacity commercial transport aircraft. The study was directed toward large twin-engine aircraft applications in the 400,000 to 500,000 pound take-off gross weight class. Four single rotation fan engine designs with fan pressure ratios from 1.3 to 1.75, and two counter-rotating fan engine configurations were studied. Several engine configurations were identified which, with further technology development, could achieve the objective of 5 to 10 EPNdB noise reduction. Optimum design fan pressure ratio is concluded to be in the range of 1.4 to 1.55 for best noise reduction with acceptable weight and Direct Operating Cost (DOC) penalties. Gliebe, Philip R. and Janardan, Bangalore A. Glenn Research Center NAS3-25269; WBS 22-781-30-12




Commercial Aircraft Propulsion and Energy Systems Research


Book Description

The primary human activities that release carbon dioxide (CO2) into the atmosphere are the combustion of fossil fuels (coal, natural gas, and oil) to generate electricity, the provision of energy for transportation, and as a consequence of some industrial processes. Although aviation CO2 emissions only make up approximately 2.0 to 2.5 percent of total global annual CO2 emissions, research to reduce CO2 emissions is urgent because (1) such reductions may be legislated even as commercial air travel grows, (2) because it takes new technology a long time to propagate into and through the aviation fleet, and (3) because of the ongoing impact of global CO2 emissions. Commercial Aircraft Propulsion and Energy Systems Research develops a national research agenda for reducing CO2 emissions from commercial aviation. This report focuses on propulsion and energy technologies for reducing carbon emissions from large, commercial aircraftâ€" single-aisle and twin-aisle aircraft that carry 100 or more passengersâ€"because such aircraft account for more than 90 percent of global emissions from commercial aircraft. Moreover, while smaller aircraft also emit CO2, they make only a minor contribution to global emissions, and many technologies that reduce CO2 emissions for large aircraft also apply to smaller aircraft. As commercial aviation continues to grow in terms of revenue-passenger miles and cargo ton miles, CO2 emissions are expected to increase. To reduce the contribution of aviation to climate change, it is essential to improve the effectiveness of ongoing efforts to reduce emissions and initiate research into new approaches.




Refined Exploration of Turbofan Design Options for an Advanced Single-Aisle Transport


Book Description

A comprehensive exploration of the turbofan engine design space for an advanced technology single-aisle transport (737/A320 class aircraft) was conducted previously by the authors and is documented in a prior report. Through the course of that study and in a subsequent evaluation of the approach and results, a number of enhancements to the engine design ground rules and assumptions were identified. A follow-on effort was initiated to investigate the impacts of these changes on the original study results. The fundamental conclusions of the prior study were found to still be valid with the revised engine designs. The most significant impact of the design changes was a reduction in the aircraft weight and block fuel penalties incurred with low fan pressure ratio, ultra-high bypass ratio designs. This enables lower noise levels to be pursued (through lower fan pressure ratio) with minor negative impacts on aircraft weight and fuel efficiency. Regardless of the engine design selected, the results of this study indicate the potential for the advanced aircraft to realize substantial improvements in fuel efficiency, emissions, and noise compared to the current vehicles in this size class. Guynn, Mark D. and Berton, Jeffrey J. and Fisher, Kenneth L. and Haller, William J. and Tong, Michael T. and Thurman, Douglas R. Glenn Research Center; Langley Research Center NASA/TM-2011-216883, L-19970, NF1676L-12004




Ultra-High Bypass Ratio Jet Noise


Book Description

The jet noise from a 1/15 scale model of a Pratt and Whitney Advanced Ducted Propulsor (ADP) was measured in the United Technology Research Center anechoic research tunnel (ART) under a range of operating conditions. Conditions were chosen to match engine operating conditions. Data were obtained at static conditions and at wind tunnel Mach numbers of 0.2, 0.27, and 0.35 to simulate inflight effects on jet noise. Due to a temperature dependence of the secondary nozzle area, the model nozzle secondary to primary area ratio varied from 7.12 at 100 percent thrust to 7.39 at 30 percent thrust. The bypass ratio varied from 10.2 to 11.8 respectively. Comparison of the data with predictions using the current Society of Automotive Engineers (SAE) Jet Noise Prediction Method showed that the current prediction method overpredicted the ADP jet noise by 6 decibels. The data suggest that a simple method of subtracting 6 decibels from the SAE Coaxial Jet Noise Prediction for the merged and secondary flow source components would result in good agreement between predicted and measured levels. The simulated jet noise flight effects with wind tunnel Mach numbers up to 0.35 produced jet noise inflight noise reductions up to 12 decibels. The reductions in jet noise levels were across the entire jet noise spectra, suggesting that the inflight effects affected all source noise components. Low, John K. C. Unspecified Center...




Aircraft Design for Reduced Climate Impact


Book Description

Aircraft affect global climate through emissions of greenhouse gases and their precursors and by altering cirrus cloudiness. Changes in operations and design of future aircraft may be necessary to meet goals for limiting climate change. One method for reducing climate impacts involves designing aircraft to fly at altitudes where the impacts of NOx emissions are less severe and persistent contrail formation is less likely. By considering these altitude effects and additionally applying climate mitigation technologies, impacts can be reduced by 45-70% with simultaneous savings in total operating costs. Uncertainty is assessed, demonstrating that relative climate impact savings can be expected despite large scientific uncertainties. Strategies for improving climate performance of existing aircraft are also explored, revealing potential climate impact savings of 20-40%, traded for a 2% increase in total operating costs and reduced maximum range.







The Dupont Aerospace DP-2 Aircraft


Book Description







1992 NASA Authorization


Book Description