Advanced Synchronization Techniques for Continuous Phase Modulation


Book Description

The objective of this research work is to develop reliable and power-efficient synchronization algorithms for continuous phase modulation (CPM). CPM is a bandwidth and power efficient signaling scheme suitable for wireless and mobile communications. Binary CPM schemes have been widely used in many commercial and military systems. CPM with multilevel symbol inputs, i.e., M-ary CPM, can achieve a higher data rate than binary CPM. However, the use of M-ary CPM has been limited due to receiver complexity and synchronization problems. In the last decade, serially concatenated CPM (SCCPM) has drawn more attention since this turbo-like coded scheme can achieve near Shannon-limit performance by performing iterative demodulation/decoding. Note that SCCPM typically operates at a low signal-to-noise ratio, which makes reliable and power-efficient synchronization more challenging. In this thesis, we propose a novel timing and phase recovery technique for CPM. Compared to existing maximum-likelihood estimators, the proposed data-aided synchronizer can achieve a better acquisition performance when a preamble is short or channel model errors are present. We also propose a novel adaptive soft-input soft-output (A-SISO) module for iterative detection with parameter uncertainty. In contrast to the existing A-SISO algorithms using linear prediction, the parameter estimation in the proposed structure is performed in a more general least-squares sense. Based on this scheme, a family of fixed-interval A-SISO algorithms are utilized to implement blind iterative phase synchronization for SCCPM. Moreover, the convergence characteristics of iterative phase synchronization and detection are analyzed by means of density evolution. Particularly, an oscillatory convergence behavior is observed when cycle slips occur during phase tracking. In order to reduce performance degradation due to this convergence fluctuation, design issues, including delay depth of the proposed algorithms, iteration-stopping criteria and interleaver size, are also discussed. Finally, for completeness of the study on phase synchronization, we investigate the error probability performance of noncoherently detected full-response CPM, which does not require channel (or phase) estimation.










Phase-Locked Loops for Wireless Communications


Book Description

This book is intended for the graduate or advanced undergraduate engineer. The primary motivation for writing the text was to present a complete tutorial of phase-locked loops with a consistent notation. As such, it can serve as a textbook in formal classroom instruction, or as a self-study guide for the practicing engineer. A former colleague, Kevin Kreitzer, had suggested that I write a text, with an emphasis on digital phase-locked loops. As modem designers, we were continually receiving requests from other engineers asking for a definitive reference on digital phase-locked loops. There are several good papers in the literature, but there was not a good textbook for either classroom or self-paced study. From my own experience in designing low phase noise synthesizers, I also knew that third-order analog loop design was omitted from most texts. With those requirements, the material in the text seemed to flow naturally. Chapter 1 is the early history of phase-locked loops. I believe that historical knowledge can provide insight to the development and progress of a field, and phase-locked loops are no exception. As discussed in Chapter 1, consumer electronics (color television) prompted a rapid growth in phase-locked loop theory and applications, much like the wireless communications growth today. xiv Preface Although all-analog phase-locked loops are becoming rare, the continuous time nature of analog loops allows a good introduction to phase-locked loop theory.













Synchronization Techniques for Digital Receivers


Book Description

Synchronization is a critical function in digital communications; its failures may have catastrophic effects on the transmission system performance. Furthermore, synchronization circuits comprehend such a large part of the receiver hardware that their implementation has a substantial impact on the overall costs. For these reasons design engineers are particularly concerned with the development of new and more efficient synchronization structures. Unfortunately, the advent of digital VLSI technology has radically affected modem design rules, to a point that most analog techniques employed so far have become totally obsolete. Although digital synchronization methods are well established by now in the literature, they only appear in the form of technical papers, often concentrating on specific performance or implementation issues. As a consequence they are hardly useful to give a unified view of an otherwise seemingly heterogeneous field. It is widely recognized that a fundamental understanding of digital synchronization can only be reached by providing the designer with a solid theoretical framework, or else he will not know where to adjust his methods when he attempts to apply them to new situations. The task of the present book is just to develop such a framework.




Radioengineering


Book Description




Digital Phase Modulation


Book Description

The last ten years have seen a great flowering of the theory of digital data modulation. This book is a treatise on digital modulation theory, with an emphasis on these more recent innovations. It has its origins in a collabor ation among the authors that began in 1977. At that time it seemed odd to us that the subjects of error-correcting codes and data modulation were so separated; it seemed also that not enough understanding underlay the mostly ad hoc approaches to data transmission. A great many others were intrigued, too, and the result was a large body of new work that makes up most of this book. Now the older disciplines of detection theory and coding theory have been generalized and applied to the point where it is hard to tell where these end and the theories of signal design and modulation begin. Despite our emphasis on the events of the last ten years, we have included all the traditional topics of digital phase modulation. Signal space concepts are developed, as are simple phase-shift-keyed and pulse-shaped modulations; receiver structures are discussed, from the simple linear receiver to the Viterbi algorithm; the effects of channel filtering and of hardlimiting are described. The volume thus serves well as a pedagogical book for research engineers in industry and second-year graduate students in communications engineering. The production of a manageable book required that many topics be left out.