Aerodynamic Characteristics of a Canard and an Outboard-tail Airplane Model at High Subsonic Speeds


Book Description

An investigation was made in the Langley highspeed 7- by 10-foot tunnel through a range of Mach numbers from 0.60 to 0.95 of the static longitudinal and lateral stability and control characteristics of a canard airplane configuration and an outboard-tail configuration. The canard model had a twisted wing with approximately 67 degrees o sweepback and an aspect ratio of 2.91 and was tested with three trapezoidal canard surfaces having ratios of exposed area to wing area of 0.032, 0.076, and 0.121. The canard model had a single body-mounted vertical tail. The outboard-tail model had its horizontal- and vertical-tail surfaces mounted on slender bodies attached to the wing tips and located to the rear and outboard of the 67 degrees sweptback wing of aspect ratio 1.00. The data, which are presented with limited analysis, provide information at high subsonic speeds on these two types of high-speed airplanes which have previously been tested at supersonic speeds and reported in NACA RM L58B07 and NACA RM L58E20 (AD-153 929 and AD-221 852). (Author).







NASA Technical Note


Book Description







The Subsonic Static Aerodynamic Characteristics of an Airplane Model Having a Triangular Wing of Aspect Ratio 3


Book Description

An investigation has been conducted to determine the effects of vertical-tail location and size on the subsonic aerodynamic characteristics of a model having a triangular wing. The wing had an aspect ratio of 3, an NACA 0003.5-63 section in the streamwise direction, and plain, trailing-edge ailerons. The wing was attached to the fuselage in either a mid or high position and an unswept horizontal tail was located on the fuselage center line. Two vertical tails were tested which had areas of 26.7 or 20.3 percent of the wing area. Each vertical tail was equipped with a rudder and had a geometric aspect ratio of 1.5, a taper ratio of 0.16, and 54 degrees of sweepback of the leading edge. Each vertical tail was tested at two different tail lengths. The wind-tunnel tests were conducted at a Reynolds number of 2.5 milMon at Mach numbers from 0.25 to 0.95.










Index of NASA Technical Publications


Book Description