Characterization ReportOperational Closure Covers for the Area 5 Radioactive Waste Management Site at the Nevada Test Site


Book Description

Bechtel Nevada (BN) manages two low-level Radioactive Waste Management Sites (RWMSs) at the Nevada Test Site (NTS) for the U.S. Department of Energy (DOE) National Nuclear Security Administration Nevada Site Office (NNSA/NSO). The Area 3 RWMS is located in south-central Yucca Flat and the Area 5 RWMS is located about 15 miles south, in north-central Frenchman Flat. Though located in two separate topographically closed basins, they are similar in climate and hydrogeologic setting. The Area 5 RWMS uses engineered shallow-land burial cells to dispose of packaged waste, while the Area 3 RWMS uses subsidence craters formed from underground testing of nuclear weapons for the disposal of packaged and unpackaged bulk waste. Over the next several decades, most waste disposal units at both the Area 3 and Area 5 RWMSs are anticipated to be closed. Closure of the Area 3 and Area 5 RWMSs will proceed through three phases: operational closure, final closure, and institutional control. Many waste disposal units at the Area 5RWMS are operationally closed and final closure has been placed on one unit at the Area 3 RWMS (U-3ax/bl). Because of the similarities between the two sites (e.g., type of wastes, environmental factors, operational closure cover designs, etc.), many characterization studies and data collected at the Area 3 RWMS are relevant and applicable to the Area 5 RWMS. For this reason, data and closure strategies from the Area 3 RWMS are referred to as applicable. This document is an interim Characterization Report - Operational Closure Covers, for the Area 5 RWMS. The report briefly describes the Area 5 RWMS and the physical environment where it is located, identifies the regulatory requirements, reviews the approach and schedule for closing, summarizes the monitoring programs, summarizes characterization studies and results, and then presents conclusions and recommendations.




Closure Report for Corrective Action Unit 107


Book Description

CAU 107, "Low Impact Soil Sites," consists of 15 CASs in Areas 1, 2, 3, 4, 5, 9, 10, and 18 of the NTS. The closure alternatives included No Further Action and Closure in Place with Administrative Controls. This CR provides a summary of completed closure activities. ROTC Justification: The FFACO UR as published in the Closure Report for Corrective Action Unit 107: Low Impact Soil Sites, Nevada Test Site, Nevada (NNSA/NSO, 2009) states that the UR for CAS 18-23-02, U-18d Crater (Sulky), was implemented for assumed radioactive contamination that could cause a dose greater that 25 millirems per year. This document further clarifies that this was based on particulate releases of radionuclides identified in Radiological Effluents Released from U.S. Continental Tests, 1961 through 1992 (DOE/NV, 1996). The radionuclides listed in this document are krypton (Kr)-85, Kr-85m, Kr-87, Kr-88, rubidium (Rb)-87, strontium (Sr)-89, Sr-91, yttrium (Y)-91, iodine (I)-131, I-132, I-133, I-134, I-135, xeon (Xe)-133, Xe-135, Xe-138, cesium (Cs)-135, Cs-138, barium (Ba)-139, and Ba-140.










Supporting Documents for LLL Area 27 (410 Area) Safety Analysis Reports, Nevada Test Site


Book Description

The following appendices are common to the LLL Safety Analysis Reports Nevada Test Site and are included here as supporting documents to those reports: Environmental Monitoring Report for the Nevada Test Site and Other Test Areas Used for Underground Nuclear Detonations, U.S. Environmental Protection Agency, Las Vegas, Rept. EMSL-LV-539-4 (1976); Selected Census Information Around the Nevada Test Site, U.S. Environmental Protection Agency, Las Vegas, Rept. NERC-LV-539-8 (1973); W.J. Hannon and H.L. McKague, An Examination of the Geology and Seismology Associated with Area 410 at the Nevada Test Site, Lawrence Livermore Laboratory, Livermore, Rept. UCRL-51830 (1975); K.R. Peterson, Diffusion Climatology for Hypothetical Accidents in Area 410 of the Nevada Test Site, Lawrence Livermore Laboratory, Livermore, Rept. UCRL-52074 (1976); J.R. McDonald, J.E. Minor, and K.C. Mehta, Development of a Design Basis Tornado and Structural Design Criteria for the Nevada Test Site, Nevada, Lawrence Livermore Laboratory, Livermore, Rept. UCRL-13668 (1975); A.E. Stevenson, Impact Tests of Wind-Borne Wooden Missiles, Sandia Laboratories, Tonopah, Rept. SAND 76-0407 (1976); and Hydrology of the 410 Area (Area 27) at the Nevada Test Site.













Energy Efficiency in Domestic Appliances and Lighting


Book Description

This book contains peer-reviewed papers presented at the 10th International Conference on Energy Efficiency in Domestic Appliances and Lighting (EEDAL'19), held in Jinan, China from 6-8 November 2019. Energy efficiency helps to mitigate CO2 emissions and at the same time increases the security of energy supply. Energy efficiency is recognized as the cleanest, quickest and cheapest energy source. Not only this, but energy efficiency brings several additional benefits for society and end-users, such as lower energy costs, reduced local pollution, better outdoor and indoor air quality, etc. However, in some sectors, such as the residential sector, barriers to investments in energy efficiency remain. Legislation adopted in several jurisdictions (EU, Japan, USA, China, India, Australia, Brazil, etc.) helps in removing barriers and fosters investments in energy efficiency. These initiatives complement innovative financing schemes for energy efficiency, the provision of energy services by energy service companies and different types of information programs. At the same time, progress in appliance technologies and in solid state lighting offer high levels of efficiency. LED lighting is an example. As with previous conferences in this series, EEDAL’19 provided a unique forum to discuss and debate the latest developments in energy and environmental impact of households, including appliances, lighting, heating and cooling equipment, electronics, smart meters, consumer behavior, and policies and programs. EEDAL addressed non-technical issues such as consumer behavior, energy access in developing countries, and demand response.




Test & Evaluation Management Guide: August 2016


Book Description

This PRINT REPLICA contains the 6th edition of the Test & Evaluation Management Guide (TEMG). The Test & Evaluation Management Guide is intended primarily for use in courses at DAU and secondarily as a generic desk reference for program and project management, and Test & Evaluation (T&E) personnel. It is written for current and potential acquisition management personnel and assumes some familiarity with basic terms, definitions, and processes as employed by the DoD acquisition process. The Test & Evaluation Management Guide is designed to assist Government and industry personnel in executing their management responsibilities relative to the T&E support of defense systems and facilitate learning during Defense Acquisition University coursework. The objective of a well-managed T&E program is to provide timely and accurate information to decision makers and program managers (PMs). The Test & Evaluation Management Guide was developed to assist the acquisition community in obtaining a better understanding of who the decision makers are and determining how and when to plan T&E events so that they are efficient and effective. Why buy a book you can download for free? We print this book so you don't have to. First you gotta find a good clean (legible) copy and make sure it's the latest version (not always easy). Some documents found on the web are missing some pages or the image quality is so poor, they are difficult to read. We look over each document carefully and replace poor quality images by going back to the original source document. We proof each document to make sure it's all there - including all changes. If you find a good copy, you could print it using a network printer you share with 100 other people (typically its either out of paper or toner). If it's just a 10-page document, no problem, but if it's 250-pages, you will need to punch 3 holes in all those pages and put it in a 3-ring binder. Takes at least an hour. It's much more cost-effective to just order the latest version from Amazon.com This book includes original commentary which is copyright material. Note that government documents are in the public domain. We print these large documents as a service so you don't have to. The books are compact, tightly-bound, full-size (8 1/2 by 11 inches), with large text and glossy covers. 4th Watch Publishing Co. is a HUBZONE SDVOSB. https: //usgovpub.com