Book Description

Excerpt from Motor Drive for Machine Tools: With a Chapter on Wiring for Motor-Driven Machinery For the shop where electric power is already installed, all kinds of machine tools may be purchased completely equipped with individual motors. When, however, it is desired to institute a change in a shop that has been employing belts and shafting, and to substitute electric power, it becomes necessary to consider each of the belt-driven tools separately, so as to secure as nearly as possible the same results that are obtained with the tools built for motor drive. At the same time excessive expenditures in the alterations must be avoided. It is the purpose of this article to outline the principles of motor application, and to suggest methods by which the belt-driven tools may be accommodated to motor drive. The first problem to consider is that of the transmission of the power. In large plants, covering acres of ground, alternating current is employed in order to permit the use of high voltages with the corresponding saving in the copper used for wiring. In plants consisting of but a few buildings, grouped fairly close together, the use of direct current possesses advantages in variable speed possibilities that far outweigh the gain to be secured by the use of the high-voltage alternating current. It is, therefore, the general practice at the present time to use 230-volt direct current for the operation of plants of the nature of machine shops, in which a large part of the load will consist of motors driving tools requiring variable speed. Where long transmissions make the distribution of power by alternating current a necessity, a motor-generator may be installed at the point of distribution for the purpose of supplying direct current to the variable-speed motors. This is often the system employed in the case of railway shops which are spread out over a considerable territory and contain a large proportion of constant-speed tools. Here the transmission current is 440 volts, alternating, and the constant speed motors are operated on this current, while the motor-generator supplies 230-volt direct current for the operation of the variable speed motors. In the first place the three types of direct-current motors should be thoroughly defined, so that the proper type may be selected for the particular tool to which the motor is to be applied. These three types are series-wound, shunt-wound, and compound-wound motors. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.