Drilled Shaft Manual: Construction procedures and design for axial loading


Book Description

Drilled shafts have been used on a limited scale for many years as an alternative to driven piles in a variety of foundation problems. However, uncertainty about the behavior of the drilled shaft has forestalled widespread adoption. The subject package, by Dr. Lymon C. Reese of the University of Texas, is intended for use by bridge engineers, geotechnical engineers, and builders of pile foundations. The manual contains rational procedures and practical guidelines for the design and construction of drilled shaft foundations. Volume I presents a rational design procedure for drilled shafts under axial loading and includes guidelines on construction methods, inspection, load testing, specifications, and cost estimates. Volume II presents alternative methods for computing the response of the shaft to lateral loading and presents the structural design of the shaft for axial and/or lateral loading.













Terzaghi Lectures


Book Description

Sponsored by the Executive Committee of the Geotechnical Engineering Division of ASCE. This Geotechnical Special Publication contains eight lectures given between 1974 and 1983 in honor of Karl Terzaghi and repressenting diverse aspects of geotechnical engineering and engineering geology. Topics include: the relationship of geology and geotechnical engineering and how a study of the geology of engineering sites is an important starting point for all geotechnical site studies; effects of dynamic soil properties on soil-structure interaction; bearing capacity and settlement of pile foundations; design and construction of drilled shafts; evaluating calculated risk in geotechnical engineering; proposal forØthe establishment of a national center for investigating civil engineering failures, with several case studies; pre-Columbian earth construction in the Americas and technological developments between 2,500 and 500 years ago; and recent progress in the design and construction of concrete-face rockfill dams. The 1978 lecture by the late N.M. Newmark is not included.







Drilled Shafts


Book Description




Masters Theses in the Pure and Applied Sciences


Book Description

Masters Theses in the Pure and Applied Sciences was first conceived, published, and dis seminated by the Center for Information and Numerical Data Analysis and Synthesis, (CINDAS) *at Purdue University in 1957, starting its coverage of theses with the academic year 1955. Beginning with Volume 13, the printing and dissemination phases of the ac tivity was transferred to University Microfilms/Xerox of Ann Arbor, Michigan, with the thought that such an arrangement would be more beneficial to the academic and general scientific and technical community. After five years of this joint undertaking we had concluded that it was in the interest of all concerned if the printing and distribution of the volume were handled by an international publishing house to assure improved service and broader dissemination. Hence, starting with Volume 18, Masters Theses in the Pure and Applied Sciences has been disseminated on a worldwide basis by Plenum Publishing Corporation of New York, and in the same year the coverage was broadened to include Canadian universities. All back issues can also be ordered from Plenum. We have reported in Volume 19 (thesis year 1974) a total of 10,045 theses titles from 20 Canadian and 209 United States universities. We are sure that this broader base for theses titles reported will greatly enhance the value of this important annual reference work. The organization of Volume 19 is identical to that of past years. It consists of theses titles arranged by discipline and by university within each discipline.




Scientific and Technical Aerospace Reports


Book Description

Lists citations with abstracts for aerospace related reports obtained from world wide sources and announces documents that have recently been entered into the NASA Scientific and Technical Information Database.